• Ciao Guest, The owner of this website and GTMotoCycles.com lost his home completely on the morning of January 8th in the L.A. Wildfire Storm. Most of his neighborhood is gone, and a few friends were killed along with their pets. The GTM SHOP and STORE are functioning normally, but we DEMAND EXTREME PATIENCE on orders as we are a SMALL business and Todd usually has his hands on nearly every order before it goes out. You can find more info on a post named L.A. Wildfires in the USA section. Our heart and best go out to everyone in this horrific disaster.

ecu

  1. J

    2016 Stornello V7 II

    Hello fellow MG riders. I am lucky enough to ride and stable the Piaggio Stornello media bike, #159. She is well ridden and kitted for BDR and pavement alike.
  2. S

    No Start.

    I'm humbly returning after a long absence, hoping someone out there can help me figure out a no-start 2014 cali touring with 22k and Todd's awesome ECU flash/PCV/AT fueling. I'm hundreds of miles away from any authorized service (w/PADS). Basically on my own. Take pity.Here's the deal...
    • Ste
    • Thread
    • ecu fall sensor immobilizer no start pads
    • Replies: 29
    • Forum: Cal 1400 8V
  3. G

    V85TT E5 and Diag

    Hi, does anyone know if the Diag will work (through the Lonelec adaptor device from UK) with my 2021 V85TT E5? The ECU on my bike is a Marelli 11MP. I have read various stories on other (less credible forums) so I don't know if it will work for my ECU. I do not immediately need to work with Diag...
  4. scott_m

    KEY and ECU source in Australia

    Well, while farting around on the internet, I stumbled upon these guys.Never heard of them before but given that many people send their stuff to the folks in Holland (Carmo), I thought it wouldn't hurt to have another option for code recovery, key programming, mileage recovery for damaged...
  5. Darwin L

    2017 V7 Stone Dies when going second to third gear

    Hi guys,i have an issue with my bike. It dies while I am riding. The issue has been somewhat consistent when I go from second to third gear the motor immediately dies. When stopped, I can turn on the motor again but the issue pops up again going from second to third. I got the message on the...
  6. sanddweller

    Sidestand Light wont go off

    Ok got a longish history on this that may or may not be related.1. Bike has been in Bribsane Australia while I have been in Dubai for 21 months. 2. I Visited Brisbane last in December and decided to ship th ebike to Dubai. Rode it to Brisbane dealer, had it crated. Id just clocked over...
  7. grmaster1

    No start with an ECU error on the dash

    The dreaded “no start” happened todayFor some reason, I’ve been watching the battery voltage for the past three days, and it went down from 14.2v (with high beams and fogs on) to 13.8-9v. That’s the only thing that was off...Tried to start it, after riding for 30 miles in 30C weather and...
  8. EV1100fan

    IAW15RC.C8 ECU fail or buy another EV1100 ?

    Hi fellow technicians, my Guzzi is not starting anymore and even though ECU reads fine with Diag and contains the latest (that I know), it shows all is okay but won't start. It failed first with only running stationary, then failed completely. I proved for myself ignition (flashlight detector)...
    • EV1100fan
    • Thread
    • california ecu ev1100 iaw15rc.c8 not starting starting problem
    • Replies: 23
    • Forum: Loop & Tonti
  9. NPS

    Fuel Map questions

    Hi Being inquisitive fellow, I would be interested to know the physics behind the additional fuel map for the right cylinder on the Breva bikes. There is a main fuel map of throttle against rpm with injector times. There is also a difference table where the values are added or subtracted to the...
  10. Raggitash

    1100 several things on dash not working.

    Hi guys,I bought a Griso 1100 in amazing condition with everything working.It was left for a couple of months (Winter) and the battery lost charge ( I didn't know), when I tried to start it everything obviously lost power.It now will not 1. Cycle through menus using the left front select...
  11. Michael Boeglin

    Just installed Hybrid Fork Kit on my ‘13 V7

    just installed the V7 hybrid fork kithttps://gtmotocycles.com/collections/suspension/products/gt-v7-v7-ii-hybrid-fork-kitOn my ‘13 V7. Easy install, just pulled off the bars and payed them over the headlamp, unscrewed the fork caps remembering they were going to pop out if I want ready to...
  12. Jkd

    ECU and Warning Lights

    Hi all - I'm looking at changing out the stock gauges and replacing with something smaller. The concern is that the replacement gauge only has one programmable general alarm / alert light.Am I stuck having to choose only one of the four (MGCT, MI, ABS, and General Alarm (RPM)) that are...
  13. Moss Jacobs

    '15 V7 Stone Flash

    How do i know if a ECU remap or "Flash" is needed? I have no relationship with a dealer, otherwise i would go and ask.. i would rather not visit a dealer. how can i determine if there is an upgrade? Can i remove my ECU and Fed Ex it to someone? i can live without a bike for a week or 2...
  14. LMR27

    Jackal Moto Gadget Install - No start

    Hi, I am new to the forums. I have been putting my 2000 Jackal back togethor with heaps of mods and a full motogadget electrical system. I have sent power to the ECU and fuel pump relays and have a no start situation that is doing my head in. I have spark and fuel pump working but seems like no...
  15. Jenko

    ECU updates. How often?

    I've just bought a new V7ii Racer. On one of my other bikes, a Triumph Bonneville, I bought an ECU downloadable program that I remapped my ECU with, after changing the exhaust, airbox and removing secondary air injection systems and O2 sensors. Yes, it does give better performance, but the main...
Back
Top