• Ciao Guest, The owner of this website and GTMotoCycles.com lost his home completely on the morning of January 8th in the L.A. Wildfire Storm. Most of his neighborhood is gone, and a few friends were killed along with their pets. The GTM SHOP and STORE are functioning normally, but we DEMAND EXTREME PATIENCE on orders as we are a SMALL business and Todd usually has his hands on nearly every order before it goes out. You can find more info on a post named L.A. Wildfires in the USA section. Our heart and best go out to everyone in this horrific disaster.

gearbox

  1. B

    A rookie question about drive shaft / final drive lubrication (on Mille GT or similar)

    Hi everybody!I recently bought 1989 Mille GT, I got no previous experience in old (or any) Guzzis. Yesterday I took the wheels off for tire change, and I've noticed that drive shaft rubber boot, rear cover of gearbox and right leg of central stand have some oil on them.Previously, I've owned...
  2. G

    Rear Diff Creak

    Hello all my name is Garrett, and I just purchased my first guzzi. 2016 V7II special abs with 12000 milesI know these bikes have there quirks but I brought it home last night I noticed when i push it into the garage there was a loud creaking (similar to an old door without wd40) coming from...
  3. T

    Driveline noise when engine braking.

    Hello, have a Breva 1100 that makes a scraping/dry bering noise when decellerating on engine brake.The sound goes away if i pull the clutch or give it a litte throttle. Hard to pinpoint excatly where the noise is coming from, my guess is gearbox, driveshaft or carc unit.Any ideas on what...
    • Tommy Sletvold
    • Thread
    • breva 1100 carc drivetrain final drive gearbox noise
    • Replies: 5
    • Forum: CARC
  4. Mitch Clyman

    Mechanics Blunder Help Gearbox

    I recently put a post up that I was having problems shifting in cold weather and was recommended using 75W 90 gear oil. It turns out my mechanic put transmission oil in my gearbox. He was confused by Guzzi listing transmission oil and not drive shaft.... I’m an American in Israel and I should...
  5. W

    Gearbox question

    Hello, New to the forum but a Guzzi owner for approximately 6 years. I have a 2009 Norge 2V. Just wondering what the end float should be on the gearlever shaft. TIA
  6. Nickscave

    V7 Classic - Loud squeal following 9k mile service

    After my 2009 V7 Classic was serviced at a reputable Moto Guzzi dealership, I experienced a loud squeal on the ride home (approximately 20 minutes into the drive, and on surface streets) and immediately pulled over. The squeal went away when I pulled the clutch lever in, but it did continue...
  7. RunnerDude

    8V Norge gear box vent tube route????

    I pulled my air box out before winter to replace oil pressure sensor. Its finally time to put it back together and I cant figure out where the open ended +-15 inch black gearbox vent hose goes. Can anyone help?
Back
Top