I had this bracket made to mount a couple of PIAA lights below my headlight on my California 1400 Custom.
It fits under my Isotta Medium windscreen mount with three 6mm screws 20 mm long, like this
You could mount this bracket straight to the lower triple clamp with 16mm long screws if you don’t have the windshield or one of the small sport windscreens for the Custom.
Here you can see the light mounting tabs level with the ground:
And here’s the lights mounted.
You can mount a standard half inch wire lead toggle switch onto the blanked hole on the left side trim panel and wire the lights into the factory fog light harness under the cover. I don’t have any photos of the connector because it was cut off by a previous owner. You can make it work.
Totally worth the effort in my opinion.
Cheers!
It fits under my Isotta Medium windscreen mount with three 6mm screws 20 mm long, like this
You could mount this bracket straight to the lower triple clamp with 16mm long screws if you don’t have the windshield or one of the small sport windscreens for the Custom.
Here you can see the light mounting tabs level with the ground:
And here’s the lights mounted.
You can mount a standard half inch wire lead toggle switch onto the blanked hole on the left side trim panel and wire the lights into the factory fog light harness under the cover. I don’t have any photos of the connector because it was cut off by a previous owner. You can make it work.
Totally worth the effort in my opinion.
Cheers!
Last edited:
