Frey
Tuned and Synch'ed
I've replaced the fuse panel with a Motogadget M-Unit V2.0. Tested most of the new circuits and they're working fine. The run/off switch, however, is not working. I'd had it apart, cleaned up contacts. Seemed to be hanging by a thread, so not surprised that it's not working. I have an aftermarket handlebar switch I'd use as a replacement, but it's got some fairly thin gauge wires. From switch, wire goes to coil control device. Can I get away with thin gauge wires to the switch or am I going to fry them? How much current goes through the coil control device?
Thanks,
Frey
Thanks,
Frey