bianco diamante
Just got it firing!
Correct setting clearance for cold starter arm to throttle control arm? Direct measurement from a machine or quoted references ONLY Many Thanks
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
There is on the linkage, the screw you make sure is backed off for tune up. This screw is set at idle after all sync etc is finished, You set this screw that controls the max of cable at lever so when lever on is 3200rpm warm. There will be play when shut off..I think you are asking about the high idle setting when starting. Basically with it released it doesn't move/touch the throttle linkage, but does move the linkage when you pull the lever. I don't think there is any specific measurement for it.
Not sure where my previous two posts disappeared to, but on the off chance they popped up somewhere.
With the cold start device in the off position i adjusted the cable at the throttle to cold start lever arm clearance to next to l nothing (a sheet of paper passed between without dragging)
With the cold start device on position this pushed the throttle control arm enough for 1850 rpm rising to 2300rpm if the handle bar lever held all the way on (you are pushing against throttle return spring & cold start return springs)
Trust this info is useful as the procedure isnt in the workshop manual.
Stay Safe