Rafael
GT Reference
Have an odd one here.
Just got done with a clutch job on my buddy's B11. Everything went well putting it together. Bike runs while driving. But stalls after its at idle for a minute or so. Also seems to be misfiring at start up.
Little history:
Was running great before the project was started.
The parts book incorrectly shows o-ring for timing sensor on top of shim. Upon start up it would not idle for more than 15 seconds. So after removing the timing sensor again I found a second shim with an o-ring under it.
Installed same shims and new o-ring with a dab of rtv.
Reset TPS and balanced the TBs and reset TPS again. Squirted some Sea Foam Deep creep into the stepper motor intake hose. Ran a VDSTS test on stepper motor, it said 'Complete' when it was done.
Seems to have improved but it still cuts out after a minute or so.
We thought that maybe the silicone is throwing off the sensor. So it came off again but this time there was no improvement in the idle. Oddly it seems to hunt around a little at idle a bit as if the sacred screw was turned but we didn't touch it. It seems like it misfires then shuts down. We kinda still suspect the timing sensor but not sure.
Any ideas for diagnostics?
Thanks in advance.
Just got done with a clutch job on my buddy's B11. Everything went well putting it together. Bike runs while driving. But stalls after its at idle for a minute or so. Also seems to be misfiring at start up.
Little history:
Was running great before the project was started.
The parts book incorrectly shows o-ring for timing sensor on top of shim. Upon start up it would not idle for more than 15 seconds. So after removing the timing sensor again I found a second shim with an o-ring under it.
Installed same shims and new o-ring with a dab of rtv.
Reset TPS and balanced the TBs and reset TPS again. Squirted some Sea Foam Deep creep into the stepper motor intake hose. Ran a VDSTS test on stepper motor, it said 'Complete' when it was done.
Seems to have improved but it still cuts out after a minute or so.
We thought that maybe the silicone is throwing off the sensor. So it came off again but this time there was no improvement in the idle. Oddly it seems to hunt around a little at idle a bit as if the sacred screw was turned but we didn't touch it. It seems like it misfires then shuts down. We kinda still suspect the timing sensor but not sure.
Any ideas for diagnostics?
Thanks in advance.