I put a pair of Oxford HotGrips on my wifes' little Breva today.
http://www.webbikeworld.com/r3/heated-motorcycle-grips/oxford-hot-grips/
I did not use the glue, the grips were a very tight fit, so the dry fitment became final fitment. I had to file down the outside end of the original throttle sleeve, trim the end of the Oxford grip on the throttle side, and put a short plastic spacer between the bar weight and the grip on the throttle side.
I modified the control mount by flattening it out and notching a mounting hole to fit under handle bar mount.
Note of caution, make sure that you test the position of both grips to clear the levers. Especially important on the throttle side, you need enough slack in the wire for WOT and return without blocking the brake lever.
full size pictures here http://www.lachniet.net/photos/Motorcyc ... index.html
http://www.webbikeworld.com/r3/heated-motorcycle-grips/oxford-hot-grips/
I did not use the glue, the grips were a very tight fit, so the dry fitment became final fitment. I had to file down the outside end of the original throttle sleeve, trim the end of the Oxford grip on the throttle side, and put a short plastic spacer between the bar weight and the grip on the throttle side.
I modified the control mount by flattening it out and notching a mounting hole to fit under handle bar mount.
Note of caution, make sure that you test the position of both grips to clear the levers. Especially important on the throttle side, you need enough slack in the wire for WOT and return without blocking the brake lever.
full size pictures here http://www.lachniet.net/photos/Motorcyc ... index.html