ok, I've emailed Todd about this, but I thought I would post on here to see if anyone has this problem, or anything similar
The bike is a 2011 V7 classic, here in the UK.
Todd did a re-flash on the ECU, that seemed to improve the low-revs power delivery, made it smoother under 3,000 RPM.
I bought the Centurion software in order to reset the TPS
Firstly, on the V7 you have to choose "install older versions" in order for the software to work. After some time on the phone to technoresearch I got the software working.
The problem is the TPS reset does not work. The TPS figure reads 3.0, I do the reset, and it count downs from 10, it hangs at 1 for a few seconds, then says "ECU not responding", with "FAIL" at the bottom. I tried it a few times, tried resetting the computer etc.
Then I discover than if I advance the throttle slightly (using the 'choke' lever on the left hand side of the handlebars) so the TPS reads 4.2 then the TPS reset works fine.
Has anyone else had this problem? Or anything similar?
The bike is a 2011 V7 classic, here in the UK.
Todd did a re-flash on the ECU, that seemed to improve the low-revs power delivery, made it smoother under 3,000 RPM.
I bought the Centurion software in order to reset the TPS
Firstly, on the V7 you have to choose "install older versions" in order for the software to work. After some time on the phone to technoresearch I got the software working.
The problem is the TPS reset does not work. The TPS figure reads 3.0, I do the reset, and it count downs from 10, it hangs at 1 for a few seconds, then says "ECU not responding", with "FAIL" at the bottom. I tried it a few times, tried resetting the computer etc.
Then I discover than if I advance the throttle slightly (using the 'choke' lever on the left hand side of the handlebars) so the TPS reads 4.2 then the TPS reset works fine.
Has anyone else had this problem? Or anything similar?
Last edited: