Hi all ,i have a 2011 stelvio which will not start, it all started a month back it stopped charging the battery,so i put a new alternator on it,it started up ok then but the volts on the dash said it was only putting 12 volts out when it was revved up to 5000, so asked on the stelvio facebook site if any one had any ideas a few said clean your earth lead ends which i did, and that's what started this none starting problem, so ive up to now replaced 4 of the relay's and checked every fuse and doubled check them all oms tested the leads to the starter which is ok had the starter off and tested it@s ok,ive checked the ECU to see if there is any bent pins in there its ok all Connections are fine. when i switch the key on the 12v relays which are on the left of the bike, one clicks but the one with the same wire's that go to starter does not click, which before this all started did,, and when you turned the ignition on you could here a click from the switch on the handle bars at the start switch which now does not have, but i tested the start switch and it was getting power to it when ignition was turned on, all so now i have the plug sign on the dash but no bad codes on the diagnostics page in the dash board set up, ive got the cable to connect my lapto to the bike and the software from guzziaidg ,which when i set it away to start connecting with bike just return's with no connections found ,so its not reading the ecu as well as everything else, ive had my multi miter ends into every lead i can find to test for power or ows it and up to now ive got good Reading for all power connections. So has any one any ideas please