• NOTICE: Starting March 24th, we've shifted to a mandatory user Account upgrade (donation) to post here. Once you've created an account, see the SITE SUPPORT section at the bottom on how to upgrade. This is to help try and cover site costs, and reduce redundant and argumentative posts. Small $ donations via our link above will not be considered. We still require ONE post in the Intro section (bottom of the main Forum section list) to introduce yourself: NO QUESTIONS THERE - THEY WILL BE DELETED; Search and read first before staring a new thread, most topics are WELL covered here. Also to NOTE, the owner of this website lost his home in the L.A. Wildfire storm in January; See the USA section for more details. Your consideration and understanding on use of this site is expected. It's NOT a free social media platform - decades of time and personal money are invested. We have a zero tolerance policy on attacks. Do NOT write us direct and ask questions unrelated to the Forum, we do not offer Tech support direct, they will be deleted.

To turn it OFF

WOW I'm astonished.
So a faulty ABS is indicated by a lack of warning lights at start up.
What happens if this fuse fails while riding Would I get lights then?
 
UPDATE
Following the comments above I've re read (perhaps read properly this time) the manual.
I'm still astonished the way it works, but I know what to look out for.
Thanks for the advice everyone
 
ABS calibration

I was noticing that since I changed tires the ABS would not let me accelerate !!!
I read through this thread and saw Scott’s comment on calibration, so I should be good tomorrow..

This all happened after I had the gauge repaired and installed new tires..

MGCT SYSTEM CALIBRATION PROCEDURE
In order to maintain the effectiveness of the MGCT system following the replacement of one or both tyres or in the case of serious wear, causing a non-compliant behaviour of the MGCT, a calibration procedure of the system must be performed as follows on a straight flat stretch of road.
Check that the tyres are inflated to the correct pressure before calibrating the MGCT system.
• Allow the engine to idle for at least 5 seconds.
• Check that the MGCT is activated at level 1 or 2. Otherwise, activate it.
• Pull the clutch lever while pressing the starter button (3) for at least 5 seconds. The activation of the process will be confirmed by the MGCT warning light (2) turning on with fast flashing.

• Accelerate to a constant speed of 30 km/h (18.64 mph) in second gear, and maintain this speed for at least 8 seconds.
• The end of the procedure will be indicated by the MGCT warning light (2) turning off. The MGCT system is active.
• Once the procedure is completed, it is necessary to switch the ignition key to (OFF) and wait for at least 60 seconds before being able to switch again to (ON).
• In case of failure to complete the procedure within 2 minutes, the MGCT warning light (2) will stay on steady and the MGCT system will remain off until switching to (OFF).
• To reactivate the MGCT system, it must
 
Um… I’m having an issue with the initial step :wasntme:

- Check that the MGCT is activated at level 1 or 2. Otherwise, activate it.
- Pull the clutch lever while pressing the starter button (3) for at least 5 seconds.
- The activation of the process will be confirmed by the MGCT warning light (2) turning on with fast flashing.

I end up with MGTC back in 0 mode.
Has anyone done this ?
I am releasing the clutch with it in first gear while pressing the starter button to start the “training/learning “ process ?
Is this supposed to be done in neutral - then go for the 30kph test ?

I’ll keep trying :giggle:
 
Be sure your tires are properly inflated. Many time when this flags, they are low.
Try a super long press/hold.
 
You must log in or register to reply here.
Back
Top