V100 saddlebags note and warning!

[viewpoint]

Had a spare 10 minutes
Quick measure up and and drilled a split pin hole
Belt and braces
Ready for the European tour next month

 

[astella]

I finally got around to addressing the desire for a redundant safety lock for the side cases on the V100. Two 3/16" marine-stainless steel safety coupler pins
here (cost around $11), masking tape, a Sharpie, a sharp 3/16" drill, and 20 minutes time, and there's a fail-safe method for securing bags.

Remove the bags, put a piece of masking tape around the outer locating tab of the slot that engages the rubber block behind the passenger peg.

Remove the rubber block (just pull up and wiggle free). Replace the bags fully forward in their travel position. Use the Sharpie from the inside through the square hole in the steel bag support to mark the tape thoroughly, concentrating on the lower forward part of the square hole. (The retainer for the rubber block engages at the upper edge of the square hole in the steel, so I chose to avoid that.)
Remove the bags without disturbing the tape, center punch the tape mark, allowing for the diameter of the 3/16" drill bit. Carefully drill through that outer tab on the bag.
Replace the rubber on the bag support, re-mount the bag fully (if in doubt, put the pillion back on!) Then use the hole in the bag to guide your drill completely through the rubber block.
Remove the bags and run the drill back and forth through the rubber block a few times to slightly enlarge the hole. A speck of silicone grease on the pins allows them to glide through the rubber much easier. I also beveled the ends of the safety pins on a bench grinder for easier insertion through the rubber. The safety pins can be installed with the spring bail either up or down, your preference.

Job complete, installing/removing the pins takes an extra 3 seconds per side. Though the spring bails are loose, I can near NO metallic vibration noise over the sound of the exhaust and engine top end whine.


View attachment 30809View attachment 30810View attachment 30811View attachment 30812View attachment 30813View attachment 30814View attachment 30815

Now, if you fail to mount the bags fully forward, the safety pins failure to engage are a tell-tale alert to the problem. And if heavy vibration or bumps should somehow defeat the molded plastic retention system Guzzi intended, there is a redundant retention mechanism to prevent backward migration of the bags.

Today I have implemented the same improvement to my Mandy. The bags fit safe and ready for the road trip I have planned for the end of May. Thanks for the tip! This is a great solution! PS: if you feel that the bags are hard to mount/remove, a little sandpaper on the upper surface of the hooks and a drop of WD40 will make them smooth to assemble.

 

[South Westerly]

Happened to me too but it was the right hand bag. Also retraced my steps and couldn't find a trace of it. I was lucky and was able to purchase a single one from a gentleman on the forum who had lost a left one and got a full set. When you get a replacement strongly suggest you follow the guidance on this forum for additional securing system. Very easy to do and definitely gives some peace of mind.

 

[Ranishdogs]

Hi all , concerned about the number of panniers being lost I thought I better investigate the modification mentioned here . I went a slightly different route by using marine grade drop pins . Same mod as mentioned at start of thread in that a 5mm hole drilled through box and rubber fittings . The pins are 5mm , 50 mm open and 40 mm closed . Give a tidy and tight grip of the bottom pannier mount . One spill on roundabout on rh side , pannier didn't budge . Car collided with lh side while overtaking and pannier stayed put . Maybe I'm cursed or driving standards have gone out the window but modification definitely worked.

 

[Stella]

Be careful if you ordered saddlebags with your V100. Didn't come with any instructions. You have to take rear passenger seat off, then push the hangers into the square holes and give the bags a hard push forward to lock into the rails. Then reinstall the rear seat to positively lock the bags on. Was very careful and checked to see if bags were secured by ushing and pulling on them. Everything seemed good. Second day with bike, went for a 100 mi ride. Got home and left bag was missing. Didn't hear it come off. Reran the route consisting of ravines, deep ditches and forests but couldn't find it. Am told there aren't any more in North America and I will have to wait till July to get a new set (at cost). Heartbroken.

Sorry to hear of your loss, thanks for posting this warning

 

[WynnD]

OK, I bought the factory panniers. I've also been very religious about installation. Making sure every tab is in the right place during mounting. Riding around Denver, I leave the bags on, but this year I've been on the road for 31days and 9500 miles between two tours and in every case, the bags are going into the motel or tent. I am very careful to not bang the mount ends against anything, so they aren't cracked or broken. And I can see where on the pillion saddle spikes the bag's tab is resting against. Just want to report that I haven't had any issues with missing bags. Everything is right where it is supposed to be. I do see some noticeable wear on the right rubber near the passenger peg and probably should order a replacement.

 

[Tonym]

Finally my panniers arrived, after watching this tread with interest and the good ideas in regards to fixing with linch pin, clevis pins etc .
I decided to take a different tack to prevent the panniers coming off in mid flight. Being reluctant to drill them at this stage I thought why not put a bung in behind the front mounting hangers/tabs once the panniers are correctly fitted.
So I just got some heater hose, put some cable ties on them (for ease of removal) and inserted them accordingly.
Did a quick overnighter earlier this week and the idea seems to work well (you may need needle nose pliers on the cable ties to assist with removal).
You cant get the bungs in unless the mounting "hangers" are in the fully forward position, and I think the bungs also act as a bit of a shock absorber /prevents vibration of the hangers ( Have read elsewhere that over time some people are saying their panniers are rattling as the plastic lugs of the hangers are starting to wear)

 

[Z8EE (Zaidy)]

I'm currently dithering on buying a Mandello v100 or an Aprilia Tuareg 660. I just sold a Tuono Factory V4 1100 and still have a 1250 GS. I use the BMW Vario cases and they are the height of simplicity and functionality. Not only do they come on and off easily but they expand if needed. Things like this give me further pause to switching to the MG brand.

 

[BDS]

I'm currently dithering on buying a Mandello v100 or an Aprilia Tuareg 660. I just sold a Tuono Factory V4 1100 and still have a 1250 GS. I use the BMW Vario cases and they are the height of simplicity and functionality. Not only do they come on and off easily but they expand if needed. Things like this give me further pause to switching to the MG brand.

I understand. My best advice is to go ride one. I have never had an issue with the Mandello hard cases. And, with bag liners, I’ve only taken the hard bags off to clean the bike. But, they are super easy to put on/take off. Traveling is a breeze. I can do a 5 day trip with just the side bags and small SW tank bag - no sweat (disclaimer - I pack light). In fact, leaving for Arkansas on Thursday.

 

[FranknStein]

I'm currently dithering on buying a Mandello v100 or an Aprilia Tuareg 660. I just sold a Tuono Factory V4 1100 and still have a 1250 GS. I use the BMW Vario cases and they are the height of simplicity and functionality. Not only do they come on and off easily but they expand if needed. Things like this give me further pause to switching to the MG brand.

I have a V100S and had a R1250GS (just upgraded to a R1300GS). If you are replacing the GS with the V100 as a touring bike, I think you will be disappointed. The GS is more comfortable, practical, and trustworthy. The advantages of my Guzzi are character, looks, sound, and (to a small degree) agility. Just my 2 cents.

 

[loudviking]

I like class and style, and simplicity. BMW's are not a Guzzi and I trust
mine to go anywhere!

 

[eljayski]

Pair of bags free, you pay shipping and PP

I ponied up for the V-100 factory hard bags and wish I had not . . .

I took them off pending delivery of Hepco and Becker bags.

I want them out of my garage but can't bring myself to put them in the recycle bin.

The locking mechanism of the left-side bag is damaged but the bag can be secured with the latches (just can't lock).

The right-side bag works fine. Both bags are scuffed from falls.

I can't seem to send photos from my phone to my computer but I can attach them to texts.

If you're interested, send me a PM and we can chat. Thank you, eljayski

 

[GTM®]

Pair of bags free, you pay shipping and PP

Since you are offering them for free, I'll leave this for now. ALL items normally like this go in the Classifieds for our donating members.