robertllr
Tuned and Synch'ed
My 2013 V7 Racer has two horns, left and right, which--according to the parts book--is correct. However, today I noticed (rather belatedly, and much to my chagrin, since I've owned the bike for about 3 years) that the right-hand horn is not sounding. Going to investigate, I was astounded to find that, not only is the right-hand horn not hooked into the electrical system, but there is no wiring harness for it--at all!. The parts book is silent on the horn harnesses. So two questions: has this happened to anyone else, and how do I go about purchasing or fabricating one and hooking it in? Thanks.
PS> If I am reading the wring diagram correctly, the horns are hooked in parallel on the sme circuit, so I should be able to simply run jumper wires from the left horn to the right horn, no?
PS> If I am reading the wring diagram correctly, the horns are hooked in parallel on the sme circuit, so I should be able to simply run jumper wires from the left horn to the right horn, no?
Last edited: